Maximize Your Network Connectivity Implementing Wan Passthru on onBGW210-700

AT&T's fiber ONTs cannot be put in 'bridged' mode, so they approximate this by provisioning "IP Passthrough" that is supposed to hand/share ... But the Arris BGW210-700 has more connection ports. The IP Passthrough and Firewall settings work for me just as you set them. Issues with AT&T Arris BGW210 ... TL;DR: These steps will show you how to essentially put your Arris BGW210-700 modem/router into “bridge” aka IP Passthrough mode, ... Much better software and ... Read more. Used this to replace the terrible Pace gateway ATT provided. Much better software and has true IP pass through if you ... There are three options, only one of which (the first) is officially supported by AT&T. Use IP Passthrough, as outlined in @Ryan's answer. Setting Up Passthrough: On the BGW210-700, navigate to Firewall > IP Passthrough. Change Allocation Mode to Passthrough. IP Passthrough: This configuration is the closest to actual bridge mode as the Arris will pass through its WAN IP address (your public IP ... 1) Open browser and go to 192.168.1.254 · 2) Go to Firewall > IP Passthrough · 3) Change Allocation Mode to "Passthrough", and Passthrough Mode to ... ... BGW210 to use IP ... I am on ATT Fiber Gigabit service and get ~700 mbps/950 mbps down/up but my wifi struggles to get anything over 175 ... Much better software and has true IP pass through if you are looking to use your own equipment. Read Less. Verified purchase: YesCondition: Pre-OwnedSold by ...