Elevate Your Cadillac Reprogramming the 2007 Escalade BCM with Passthru III for Soaring Performance

Have the dealer reprogram the driver door switch (DDS) and passenger door switch (PDS) using SPS and Pass-Thru method, with updated software calibrations. Your Launch X431 Diagun will not program a GM body control module. You will need a Tech 2 or a pas through device and a subscription to GMs service website. If yes, using the Jaguar Land Rover approved diagnostic equipment, run the application 'Ignition cycle counter reset' from ECU Diagnostics – Body Control Module ... If the BCM still fails to reprogram try the following steps: Turn the ignition key off and remove it from the ignition. Open and close the ... Supports more than 7000 vehicle modules, ensuring compatibility with a vast array of cars and models. OBDII Programming Vehicles are programmed via the ... Their is a relearn procedure that has to be performed to start the car. Check the internet for GM VATS relearn procedure. From what I've been ... The BCM in this vehicle functions as a gateway or translator. The purpose of ... pass-through hole located on the dash panel on the left hand side of ... Mongoose-Plus GM 3 is a low-cost, high-performance reprogramming diagnostics interface for GM vehicles. It supports TIS2WEB for module ... This video will guide you thru the process of programming a GM with an Autel. I go over what tools are required. When the BCM and TCM come back online, are you seeing any strange codes, or just loss of communication with the PCM? I'm seeing pin 20 for the ...