Optimize Your Internet Performance D-Link DIR-655 Passthrough DHCP for Seamless Streaming

In order to set up your D-Link DIR-655 router, you will need to connect it to your modem using an Ethernet cable. Then, open your web browser and enter the ... Once that is set up properly, enable DHCP on the router and have your internal network obtain their addresses from the DIR-825. The router will ... This guide will walk you through the steps of port forwarding on the D-Link router DIR-655 (Firmware 1.32NA). eth1: link down. DHCP broadcast 1. DHCP broadcast 2. DHCP broadcast 3. DHCP ... 655 without issue and the AP was able to obtain an IP through DHCP. Thanks ... Under Setup or Basic/Networking, enter an available IP address (192.168.0.50-.59 is recommended by D-Link) and the subnet mask of your network, usually 255.255. Step 1: Unplug the Power to your Cable/DSL Internet Modem. User-added image. Step 2: Connect an Ethernet cable from your computer/laptop to a LAN port. 1. Connect a computer to the D-link router and launch a web browser. 2. Visit the following router configuration page: http://192.168.0.1 3. You are prompted ... Secure Multiple/Concurrent Sessions - The DIR-655 can pass through VPN sessions. ... U.S. and Canadian customers can contact D-Link technical ... The USB acts as 3G modem for a single PC that's connected to it, what I want is to share that internet using my D-Link DIR-655 router so I'd ... First off, open your router's admin login page, and log in. · Find and enter the DHCP section. · You should see a button that will Enable DHCP on your Dlink DIR- ...