Unleash Connectivity D-Link DIR-655 Passthrough Mode Guide

1. Make sure you have the DIR-655 connected to your current network via cat5/6 cable and make sure you are plugged into a LAN port of the DIR-655. This Forum Beta is ONLY for registered owners of D-Link products in ... mode. The settings of DAP-1360 are: Enable wireless: Always To do that you'll need to run the 655 in router mode. If you have a main host router, use the main host routers filtering and blocking features ... I have went through your steps to the T. I am using the 2 Dlink DIR-655s Setting up to step 4 works great but when trying to connect the to a ... D-Link Default Password List ; DIR-655, admin, [none] ; DIR-657, Admin, [none] ; DIR-660, Admin, [none] ; DIR-665, Admin, [none] ; DIR-685, Admin, [ ... It looks like "bridge mode" turns it in to a dumb router without firewall filtering. ... through comcast make sure to take the battery out too). I've used all modems in bridged mode (preferred mode by ISP); Check ISP ... through DIR-655 and it also lagged down to 1500-1800ms. Also ... You can configure the DIR series router with out connecting the device to a main host router with a LAN cable by setting a Static IP address on ... There should be a setup wizard in the router firmware which can be accessed using your browser, type in 192.168.0.1 into the browser address ... ... DIR-655 can pass through VPN sessions. It supports multiple and concurrent IPSec and PPTP sessions, so users behind the DIR-655 can securely ...