The Ultimate Guide to MikroTik WAN Passthru for Network Pros

The MikroTik passthrough is completely layer 2, i.e. all traffic from the chosen passthrough MAC address is forwarded to the LTE interface and vice versa ... You can change your main router ip addres to use the gateway ip which is 25.222.15.146/29, and point everything else including your server to ip ... ETH1 is the WAN port, ETH3 is the trunk port to the next MT router. WAN traffic is VLAN100, LAN traffic is VLAN200 on the trunk. Both VLANS are ... again. LTE inteface can be passthrough to other ethernet port of other ETHERNET device. Of course you can do a "bridge-wan with sfp+ and ... If you enable passthrough the LTE device will only be used for IP configuration, modem settings etc... So you will have to deal only with the ... Using an RB750. On the WAN port, it has untagged Internet connection (with static public IP) and a tagged vlan5 management VLAN. LAN side of the ... I have two WAN connections. One is fibre provided by PPPoE (ether1), the other DHCP (ether7) from a Mikrotik LTE dish configured for passthrough ... The first step in configuring an LTE router for passthrough is accessing the router's management interface. This can be done through either Winbox or the ... Anybody using HA behind Mikrotik? How do you pass through the connection? Mind share your experience ... mikrotik to redirect to local ip. The most common use of SNAT is to connect many devices to the internet, using fewer IP addresses than the number of devices. In the case of ...