Experience Unparalleled Sound Subs Passthru for Immersive Home Theater

The speaker cable would come out of your receiver's system A, into the 'High Level Input' on the back of the sub (right side), then out of the ' ... The speaker output connections on a subwoofer are powered by your receiver (or other amplifier) if you use the speaker level inputs on the subwoofer. It depends on the amp and how it was designed. Some (not all) of the amps that we use in our subs actually use the Right side input as the ... The output of your Audio source should be connected to the Left(mono)/Right TRS, or RCA ports in the "Inputs" section on the back of the Sub. It has dual inputs in case you have a receiver with dual outputs that are actually in stereo. In that event you'd miss whatever was being sent ... If your amp doesn't have this, you will need an active sub that has high level signal pass through. Simply connect one of the channels to the ... Note that one that sub, two of the speaker level connections are "inputs" and two are "outputs". The posters above went over it already, but ... ... pass through and into the subs, assuming the subs have a crossover. ... Stereo line input (7/8) for drums - I have a Focusrite Saffire Pro ... The best sub integration is the one that places the sub in the best sounding location and there's some DSP room correction in the mix. Subs are ... Some have line-level "pass-through" so you get a full active crossover with the signals going to your main amp (or active speakers) are high- ...