Input Magic Sub Passthru Transforms Network Connectivity

... subs have what they call "high-pass" thru built in. Using this ... My sub appears to have only 1 input(not counting the 1/4"), and 1 ... Sub inputs to OUT left and right; Power amp inputs to OUT blue and green. Select input 1 when using the Schiit, input 2 when using the HTR. The output of your Audio source should be connected to the Left(mono)/Right TRS, or RCA ports in the "Inputs" section on the back of the Sub. Simply run an RCA cable from sub 1 RCA pass thru output to sub 2 input -. Or simply run a balanced XLR cable from sub 1 pass thru output to sub 2 input -. The ... It has dual inputs in case you have a receiver with dual outputs that are actually in stereo. In that event you'd miss whatever was being sent ... If you've fed the R mixer output into the R input on a sub, you are unlikely to get any sound from the sub, but the signal will be passed through to the ... It takes more power to reproduce low freqs than high, so if you pump 1000 watts of full range to the sub, whatever portion of the upper spectrum it CAN ... The video shows you connecting the wires from the receiver to the sub INPUT connectors. But no mention of how the signal is then passed to ... The analogue outputs on the back of the L3s are straight forward pass-thru's so whatever is on the analogue inputs is on the analogue outputs. Replaced my factory non-B&O subwoofer and amp last night. I cut the factory amp high-level input wires and wired them to the Kicker 500.1 ...