Empower Your Network with Sub Passthru A Gateway to Efficiency

Sub inputs to OUT left and right; Power amp inputs to OUT blue and green. Select input 1 when using the Schiit, input 2 when using the HTR. One (to your speakers) incorporates a high pass filter, like a speaker crossover. The other ... the signal that the sub uses, will pass through ... Does the sub amp amplify the output to the speakers or is it a pass-through? Also would I disconnect the single Lo level input to the sub if I ... Is it possible the high level inputs of a subwoofer actually consume some of the main power amp's power? ... subs have what they call "high-pass" thru built in. Using this ... My sub appears to have only 1 input(not counting the 1/4"), and 1 ... According to DefTech (online manual), if you use the high level inputs, the crossover in the sub sends everything over 80 Hz to your mains. The ... would need to go from the cinch output of the hi low conv to the + and - cable braids input of the sub. ... Passive subs have pass-through ... The speaker level inputs and outputs are there so you can connect an amplifier speaker output to the sub then the sub to the speakers. It depends on the amp and how it was designed. Some (not all) of the amps that we use in our subs actually use the Right side input as the ... ... sub amp. If you wanna run all the RCAs to the main amp, then use the passthrough to the sub, all you should need is the main RCA harness. I ...