Maximize Network Performance with WAN Passthru on ONBGW210-700

Much better software and has true IP pass through if you are looking to use your own equipment. Read Less. Verified purchase: YesCondition: Pre-OwnedSold by ... How to do IP Passthrough on the BGW210-700? · Connect the USG WAN port to any “Ethernet“ port on the AT&T Gateway · Click the Firewall tab · Now ... I have a remote site in LA currently running a Sonicwall TZ500 behind a ATT Fiber connection (BGW210-700) in IP Passthrough mode and it's been working fine. Their setup is a BGW210-700 combo modem/router connected to their ONT. One must use their IP Passthrough in order to use personel equipment. the BGW210 really really sucks. ATT has no good routers. IP Passthrough is very inconsistent. Some people say they get it to work and some ... The Arris BGW210-700 should be set to full-bridge mode so that the Orbi Pro router will be the main router on the network. -On your AT&T Arris box go to Firewall > IP Passthrough. Set the passthrough mode as DHCPS-fixed. Here you will input the Firewalla MAC address. AT&T's fiber ONTs cannot be put in 'bridged' mode, so they approximate this by provisioning "IP Passthrough" that is supposed to hand/share ... When configured for IP Passthrough (Passthrough Mode) the AT&T provided gateway shares its Dynamic WAN IP address with a single device on the LAN. ... (BGW210-700) using the following steps. Inspect the router stickers to find ... IP Passthrough should not be used for most home networks.