Unleash the True Potential of Your Internet with WAN Passthru on ONBGW210-700

AT&T fiber jack --> Arris BGW210 [in pass-through mode] --> AmpliFi ... IP found in /etc/pihole/setupVars.conf (https://discourse.pi ... TL;DR: These steps will show you how to essentially put your Arris BGW210-700 modem/router into “bridge” aka IP Passthrough mode, ... I'm using their Arris BGW210-700 combined modem/router because, as I ... So making the router into a dumb modem via the Firewall->IP Passthrough ... While setting up our AT&T fiber internet, I needed a way of getting the 802.1x certificates off the Arris BGW210-700 residential gateway ... Thanks for reading. Here's my setup: AT&T Fiber (BGW210-700) router ... PS: IP passthrough is set to Off on the AT&T modem. Not sure if this needs to ... Setting Up Passthrough: On the BGW210-700, navigate to Firewall > IP Passthrough. Change Allocation Mode to Passthrough. All, I have an Arris ( BGW210-700) set up as 192.168.2/24 (DHCPed) and have successfully configured the IP Passthrough to the PA-220. I configured the pass through by disabling all firewalls, setting the ip passthrough to manual, allowing inbound traffic and adding the IP block ... The steps I took to configure an AT&T (Arris) BGW210-700 router for IP Passthrough mode, going to a Unifi Dream Machine Pro. This happens about every hour or so. I currently have a BGW210-700 with 4.28.7 firmware. I am running that in passthrough mode with an OPNSense ...