Unveiling the Secrets of Ford PCMs In-Depth Passthru Programming Guide

To reset, don't we just pull the negative battery terminal for like 40 minutes or so?? Dealer wanted to charge me an hour labor to reprogram ... I heard that if I use a J2534 pass-thru device with Ford FJDS and an active license, that I cannot program modules on the MS-CAN bus even with J2534-2 ... The j2534 protocol means that my gm nano is capable of being used as pass thru for any make for module programming. Or is it still tied to gm and its vpw and ... The expensive part is the J2534 pass through device, which will set you back between $600 to $1200 or more. Check www.cardaq.com for a ... ... pass through scan tool. I didn't see it as an option which is ... Ford F-150 ... And to install it, you need a scan tool with reprogramming capability, or a J-2534 or J-2534-1 PassThru tool. For a list of subscription fees and OEM technical ... The Service Programming System (SPS) updates the flash calibration files that are stored in a vehicle onboard controller (e.g. PCM, ABS, VTD). However, I did run into several failures and made various attempts to overcome them, but have not been successful yet. PCM Update --> This ... ... PCM to the laptop via a pass thru device. Also the cheap PCM is to ... program the 2003-04 CV PCM. Question: 1-Can I purchase PCMflash from ECUTOOLS.EU ... ... Programming Pass Thru Device. ... Programming & Installation of new ECU's, PCM, ABS, Instrument Cluster, Air Bag, Fuel Pumps, etc. 2. Live Data-stream with ...