Harness the Power of MikroTik WAN Passthru for Optimal Internet Connectivity

I was able to connect it to a single PC which gets the public LTE ip. I can also plug ethernet 2 to one of the WAN ports of my dual router ... [admin@MikroTik] > /ip firewall filter print [admin@MikroTik] > /ipv6 firewall filter print ... passthrough 29 320 602 344 22 976 648 ... I have two WAN connections. One is fibre provided by PPPoE (ether1), the other DHCP (ether7) from a Mikrotik LTE dish configured for passthrough ... I have a range of IP addresses available from my ISP. Of which I used with a Mikrotic, it had PPPOE bridge, which allowed me to connect equipment on specific ... So one thing you can try is setting the outbound interface Unbound is using using in Services > DNS Resolver. If you set that to WAN (DSL) ... The MikroTik passthrough is completely layer 2, i.e. all traffic from the chosen passthrough MAC address is forwarded to the LTE interface and vice versa ... MikroTik RouterOS v7 dual DHCP WAN recursive failover w/ PCC load ... passthrough=yes per-connection-classifier=both-addresses-and-ports:2/0. add ... Re: SXT LTE IP Passthrough ... 100% your provider is giving you a private IP (NAT OR CGNAT). Same will be if you are not using Passthrough. 2. Allow LAN and WAN ports to access Mikrotik by IP. ... 1. In LTE APNs I set Passthrough and it works well - whatever I connect to ether1 get's ... When a device is configured in passthrough mode, it will be assigned a WAN IP instead of a LAN IP. Other devices connected to your gateway may ...