Unleashing the Power MikroTik Passthru WAN Port for Seamless Internet Access

Which device? You have to configure it first in LAN. By default access is permitted only from LAN. In the config you can specify access from WAN ... At router end, a port not part of the bridge with DHCP client on it to receive LTE wan address, and hanging off that a matching vlan for admin, ... add address-pool="pool dhcp" disabled=no interface=bridge_LAN name=\ "dhcp server". /interface bridge port ... new-connection-mark=ISP1_conn ... What i basically need is to connect my ISP to my Mikrotik router, using the Eth1 as WAN (IP address dynamically assigned from my provider). The ... As we need the address for port 9 which is the WAN port, we can add the last two hex number digits by 8 to get the correct MAC address (remember ... ... WAN passthrough=no port=22,2200 protocol=tcp add action=mark-packet chain=postrouting new-packet-mark=prio1 passthrough=no port=8291 protocol= ... Then do your port forwarding on the Mikrotik, and also add a route to your internal network so it knows how to reach it. If you configure pass ... The first step is to configure the two PPPoE clients, one for each WAN connection. The primary PPPoE connection will be set with the default ... ... passthrough=yes per-connection-classifier=\ both-addresses-and-ports:2/0 src-address=10.10.10.0/24 add action=mark-connection chain ... Yes. If you want it to work from both WANs, then you can't have in-interface=eth_Wan2 in dstnat rule. If you don't want to have duplicate rules, ...