Unlock Seamless WAN Connectivity The Essential Guide to Mikrotik Passthru WAN Port

I'm using a Mikrotik router as LTE modem. The internet connection is configured as IP passthrough on the VLAN2. Vlan3 (192.168.88.1/24) is the management VLAN. Right – the only things that make a port "the WAN port" are 1) it's not bridged to the rest, 2) there's a NAT rule for outbound packets. ETH1 is the WAN port, ETH3 is the trunk port to the next MT router. WAN traffic is VLAN100, LAN traffic is VLAN200 on the trunk. Both VLANS ... In this video we will learn how to configure Mikrotik Router WAN ... ports:2/0 action=mark-connection new-connection-mark=WAN1_conn passthrough ... add address-pool="pool dhcp" disabled=no interface=bridge_LAN name=\ "dhcp server". /interface bridge port ... new-connection-mark=ISP1_conn ... Remove ether2 from "LAN bridge", create another bridge, add ether1 and ethe2 as slave ports and move WAN IP and VLAN config from ether1 to WAN bridge. I was able to connect it to a single PC which gets the public LTE ip. I can also plug ethernet 2 to one of the WAN ports of my dual router ... That sounds like Telus's Bridge Mode, which gives one port a public IP, and keeps another for the router to NAT behind. Upvote Ok for me with a MikroTik router the passthrough mode worked when 2min DHCP lease time was configured (in two places). However, I went back to ... The clarification I need is, and I should have been clearer on this, whether the PASSTHROUGH=NO in Packet Marking Rules 5-8 stops Packet Marking ...