Unlock the Gateway to Uninterrupted Internet with MikroTik WAN Passthru

Place the WAN address you want for the phones on a bridge or switch that contains a) the port that the ISP is coming in on b) the logical "WAN" ... Network uses VLANs 10, 20, 30 and 40 for various other things and I've set up VLAN90 for this WAN connection. Topology: Mikrotik RB1100 - WAN1 ... I have a range of IP addresses available from my ISP. Of which I used with a Mikrotic, it had PPPOE bridge, which allowed me to connect equipment on specific ... add action=mark-routing chain=prerouting connection-mark=DD02 in- interface=BridgeLAN new-routing-mark=DiraWAN2 passthrough=yes. Thẻ IP → ... Easiest might be to create a second bridge and bundle all WAN ports to it (that would be ether1, 4 and 5 in your case). Move DHCP client from ... interface lte apn set [ find default=yes ] apn=default ip-type=ipv6 use-network-apn=no add apn=everywhere authentication=pap ip-type=ipv4 ... Z tego wynika, że do pierwszego portu mamy wpięty kabel od naszego ISP (nasz główny WAN) a porty 2-5 są to porty LAN dodane do bridge1. I need to create a slave Wifi Interface on the R3 router which (somehow) directly connect the the R1 network (192.168.1.0/24) and assign ip addresses with DHCP ... If you enable passthrough the LTE device will only be used for IP configuration, modem settings etc... So you will have to deal only with the ... Be it port mapping or port forwarding, it's just another name for NAT. This short video shows how to set up Network Address Translation or ...