Empower Your Sound System Input Passthru for Unmatched Clarity

The analogue outputs on the back of the L3s are straight forward pass-thru's so whatever is on the analogue inputs is on the analogue outputs. One method is to highpass the main speakers 1st order at say 80Hz, by decreasing the power amplifier boards input coupling capacitor. ... subwoofer's high-level pass-thru degrading the signal to the speakers? You need to check the specs on the sub amp. Some are a pass through ... The outputs are direct pass-through of the input signal so it is not affected by the subwoofers DSP, so there is no degradation to the signal. We have chosen to ... Connect using an RCA cable if there isn't an LFE subwoofer output or LFE input. If the subwoofer features spring clips, use the speaker output ... Just use a single RCA, the Kicker HS10 only needs mono input and nothing will be lost. · Use a Y splitter to go from head unit mono output to ... Replaced my factory non-B&O subwoofer and amp last night. I cut the factory amp high-level input wires and wired them to the Kicker 500.1 ... According to DefTech (online manual), if you use the high level inputs, the crossover in the sub sends everything over 80 Hz to your mains. The ... ... subwoofer or LFE output connected to the subwoofer's input. Also, we'll assume the subwoofer is powered—that is, it has a built-in power amplifier, and also ... The lower frequencies on the mains are not crossed over that I assume would happen if the signal was allowed to pass through the subs on its way ...