Master Sub Passthru Enhance Network Connectivity with Ease

I've heard that this will provide better quality then using the other analog inputs (ie CD etc) *I'm worried that running through the receiver ... The lower frequencies on the mains are not crossed over that I assume would happen if the signal was allowed to pass through the subs on its way ... It takes more power to reproduce low freqs than high, so if you pump 1000 watts of full range to the sub, whatever portion of the upper spectrum it CAN ... In the Lyngdorf 3400, high pass the speakers at 80 Hz 12 dB/octave and low pass the sub-out signal at 80 Hz 24 dB/octave. ... Make sure to use the LFE input on ... The proper connection for a subwoofer is from the speaker output connectors of a power amplifier. But, how does this circuit work on the ... The speaker cable would come out of your receiver's system A, into the 'High Level Input' on the back of the sub (right side), then out of the ' ... One (to your speakers) incorporates a high pass filter, like a speaker crossover. The other ... the signal that the sub uses, will pass through ... No, the amplifier and the speakers need to meet at the subwoofer. The speaker level inputs are a pass-through. The best sub integration is the one that places the sub in the best sounding location and there's some DSP room correction in the mix. Subs are ... Subs typically accept low-level input (RCA usually but XLR falls under this category too) and high-level input (speaker wire connection).