Empower Your Network Configure MikroTik Passthru for Enhanced WAN Management

i find out that the problem was that i had in.interface ether 24, that is the port that is connected to the isp router, at the nat roule. when i ... add address-pool="pool dhcp" disabled=no interface=bridge_LAN name=\ "dhcp server". /interface bridge port ... new-connection-mark=ISP1_conn ... ... WAN add comment=defconf name=LAN /interface lte apn add apn=free ... MikroTik /ip hotspot profile set [ find default=yes ] html ... - The LAN network is connected to a managed switch, with the VLANs setup already. With the ASUS, this is working. ... How could I setup this in ... I have a range of IP addresses available from my ISP. Of which I used with a Mikrotic, it had PPPOE bridge, which allowed me to connect equipment on specific ... Best way IMO would be to convert your current WAN+LAN setup to all-VLAN setup. So you would add all ports (including current WAN port to same bridge and use ... ETH1 is the WAN port, ETH3 is the trunk port to the next MT router. WAN traffic is VLAN100, LAN traffic is VLAN200 on the trunk. Both VLANS ... ... ports:2/0 action=mark-connection new-connection-mark=WAN1_conn passthrough=yes add chain=prerouting dst-address-type=!local in-interface ... I'm using a Mikrotik router as LTE modem. The internet connection is configured as IP passthrough on the VLAN2. Vlan3 (192.168.88.1/24) is the management VLAN. Ideally the WAN would come in to the HAP AC at port 1, this ... add comment="WAN Passthrough VLAN" interface=ether5-trunk-to-b1 name ...