Maximize WAN Capabilities A Beginner's Guide to MikroTik WAN Passthru

Mám MikroTika, kterém jsou 2 WAN porty, každý od jiného ISP a na každém je veřejná IP. Veškerý provoz do internetu (0.0.0.0/0) routuji na WAN2(=eth2), přes WAN1 ... WAN IP Passthrough with Bridge Modem / FTTC ... On this connection, I have a block of static WAN IPs assigned to me. I can add these other IPs to ... I will assume you have read MikroTik's documentation on PCC, Nth, Mangle etc. ... passthrough=no ###Incoming connections through ISP2 must ... Log in to the MikroTik device using the WebFig web-based interface. Navigate to the "Interface" tab and click on the "WAN" interface. In the " ... Using an RB750. On the WAN port, it has untagged Internet connection (with static public IP) and a tagged vlan5 management VLAN. LAN side of the ... That sounds like Telus's Bridge Mode, which gives one port a public IP, and keeps another for the router to NAT behind. yes that's correct ..! ether4-5=LAN2 with ip range 192.168.1.1/24 and it contain only the VPN traffic -ether3 - so all LAN2 traffic pass through ... By default, connections from LAN to WAN are not restricted in any way. The only requirement us a working SRC-NAT configuration (which is there ... Set your Mikrotik router as DNS server for the clients · Run the following script every 10 seconds or so, to find in DNS table all netflix ... ... WAN connection gets no traffic. The 2 WANs are RAIN 5G and Telkom LTE; Rain 5G is on Ether 1 and has IP Passthrough enabled so i get a 10.