Simplify WAN Configuration Unleash the Power of MikroTik Passthru

In this example I have used Mikrotik Routerboard CCR 1036 model. 4 ports are connected with Four DSL Routers, and 5th port was connected with ... That means you can directly connect an Ethernet cable to the Nokia ONT to your router WAN port. ... Setup your smart switch (eg: MikroTik CSS326 ... So, two connections among three connections will pass through WAN1 connection and one connection will pass through WAN2 connection. WAN ... I'm using a Mikrotik router as LTE modem. The internet connection is configured as IP passthrough on the VLAN2. Vlan3 (192.168.88.1/24) is the management VLAN. Network uses VLANs 10, 20, 30 and 40 for various other things and I've set up VLAN90 for this WAN connection. Topology: Mikrotik RB1100 - WAN1 ... For failover of PCC you have options. 1. the failover will go to the WAN with the lowest distance only ( so lets say WAN5 had the lowest ... ... passthrough=yes per-connection-classifier=both-addresses-and-ports:2/0 src-address=10.10.10.0/24 add action=mark-connection chain=prerouting ... Hello All, I want to use an MOTG equipped with a 3G/4G USB modem simply as “WAN selection mechanism” in front of a Mikrotik VPN router. When passthrough enabled, the LHG ends up on the WAN side with no IP address and routers generally don't pass MAC layer traffic between the WAN and LAN side. ... port was connected with User LAN. Also don't forget to rename the interface ... passthrough=yes add action=mark-connection chain=input comment ...