Maximize WAN Connectivity A Comprehensive Guide to MikroTik WAN Passthru

1) create a bridge also for WAN interface and attach WAN ethernet port to it. · 2) create 2 VLAN4 interfaces. · 3) create a 3rd bridge and bind ... The goal is basically to passthrough one of the 2 WAN connections and when preferred connection (dynamic DHCP) goes down switch to the secondary ... If I remove VLAN 99 from bridge and add it as slave on ether ports between routers, LTE passthrough add addresses well, and can ping from Router ... Log in to the MikroTik device using the WebFig web-based interface. Navigate to the "Interface" tab and click on the "WAN" interface. In the " ... To configure your Mikrotik router to assign the IP address by DHCP you would use the following scripts: /ip pool add name=pool_100 ranges=87. yes that's correct ..! ether4-5=LAN2 with ip range 192.168.1.1/24 and it contain only the VPN traffic -ether3 - so all LAN2 traffic pass through ... ISP delivers two VLANs on WAN (VLAN300 for Internet(tagged) and VLAN640 for IPTV(tagged) - VLAN640 needs to be passed through on the LAN as tagged with the ... I have two WAN connections. One is fibre provided by PPPoE (ether1), the other DHCP (ether7) from a Mikrotik LTE dish configured for passthrough ... Remove ether2 from "LAN bridge", create another bridge, add ether1 and ethe2 as slave ports and move WAN IP and VLAN config from ether1 to WAN bridge. Set ether9 and ether10 into a bridge named bridge_wan. Disable all DHCP clients and servers in this bridge. Remove addresses from the ports in this bridge.