Simplify Network Management Mikrotik WAN Passthrough for Efficient Data Flow

I can get each WAN interface to work independently when disabling the other WAN Interface. My goal is to have Bridge1 Traffic only route out ... The Firewall | IP Passthrough tab was, obviously, the most important page in this process. I needed to set the Allocation Mode to “Passthrough” ... Set ether9 and ether10 into a bridge named bridge_wan. Disable all DHCP clients and servers in this bridge. Remove addresses from the ports in this bridge. Preliminary setup: You will need to set up the two WAN connections. Assume IFC1 to be the first WAN port (e.g. ether1 ) interface and IFC2 ... ... MikroTik /ip pool add name=dhcp_pool0 ranges=192.168.88.2-192.168.88.254 add ... passthrough=yes per-connection-classifier=\ both-addresses:2/0 add ... Welcome to Learn Mikrotik Configuration Series - Tutorial no. 20 "HOW TO GIVE PING/ICMP HIGH PRIORITY IN MIKROTIK ROUTER" In this video you ... Remove ether2 from "LAN bridge", create another bridge, add ether1 and ethe2 as slave ports and move WAN IP and VLAN config from ether1 to WAN bridge. ... WAN connection gets no traffic. The 2 WANs are RAIN 5G and Telkom LTE; Rain 5G is on Ether 1 and has IP Passthrough enabled so i get a 10. IPv6 wan settings on pfsense and mikrotik passthrough configuration ... CHR is used to manage a cat 16 lte modem to passthrough (bridge) the LTE ... I was able to connect it to a single PC which gets the public LTE ip. I can also plug ethernet 2 to one of the WAN ports of my dual router ...