Maximize WAN Efficiency The Ultimate Guide to Mikrotik Passthru WAN Port

... passthrough=yes add action=mark-connection chain=input connection ... port=5060 new-routing-mark=SIP-WAN3 passthrough=no protocol=udp ... To enable passthrough mode, you must bind the LTE interface to a specific Ethernet port on the router. The most common setup is binding the LTE ... Which device? You have to configure it first in LAN. By default access is permitted only from LAN. In the config you can specify access from WAN ... Responses (23) ... It's actually pretty simple. Connect one of the ports on the BGW to the WAN port of the UDM Pro. You'll need to enable 'IP Passthrough' on the ... /interface bridge port add bridge=bridge ingress-filtering=no interface=ether3. / ... passthrough=yes per-connection-classifier=both-addresses-and-ports:2/0. add ... Pro obe wan nastav dst-nat port forward. Pro wan1 pak ještě src-nat, který ... passthrough=no src-address=_WAN2GW_. To co jsem psal výše mi funguje pro ... Otherwise, when a packet enters e.g. wan 1, it will still enter the hashing procedure, since you do not define that only unmarked packets can be ... If you enable passthrough the LTE device will only be used for IP configuration, modem settings etc... So you will have to deal only with the ... Hello My friends..! so i have RB951ui and want the LAN 4 + 5 ports on it to use port 3 as the WAN interface like this scenario. ... ports:2/0 action=mark-connection new-connection-mark=WAN1_conn passthrough=yes add chain=prerouting dst-address-type=!local in-interface ...