MikroTik Passthru WAN Port Unveiled Your Gateway to Network Freedom

In this example I have used Mikrotik Routerboard CCR 1036 model. 4 ports are connected with Four DSL Routers, and 5th port was connected with ... At router end, a port not part of the bridge with DHCP client on it to receive LTE wan address, and hanging off that a matching vlan for admin, ... 2. Allow LAN and WAN ports to access Mikrotik by IP. ... 1. In LTE APNs I set Passthrough and it works well - whatever I connect to ether1 get's ... add address-pool="pool dhcp" disabled=no interface=bridge_LAN name=\ "dhcp server". /interface bridge port ... new-connection-mark=ISP1_conn ... ... passthrough=yes per-connection-classifier=both-addresses-and-ports:2/0 src-address=10.10.10.0/24 add action=mark-connection chain=prerouting ... To enable passthrough mode, you must bind the LTE interface to a specific Ethernet port on the router. The most common setup is binding the LTE ... Ideally the WAN would come in to the HAP AC at port 1, this ... add comment="WAN Passthrough VLAN" interface=ether5-trunk-to-b1 name ... Which device? You have to configure it first in LAN. By default access is permitted only from LAN. In the config you can specify access from WAN ... If I remove VLAN 99 from bridge and add it as slave on ether ports between routers, LTE passthrough add addresses well, and can ping from Router ... Comments17 · How to distribute your Public Ip's Internally. · MikroTik Tutorial 28 - Port Forwarding · Full MikroTik MTCNA - PPP & PPPoE · Full ...