Mastering WAN Connectivity MikroTik WAN Passthru for Experts

I need to create a slave Wifi Interface on the R3 router which (somehow) directly connect the the R1 network (192.168.1.0/24) and assign ip addresses with DHCP ... #MikroTik #RouterOS #MikroTik_QOS The export of the configuration of the ... ont wan-config 0 4 ip-index 0 profile-id 1 ont port route 0 4 eth 1 enable ... With VirtualHere this is no longer required, the network itself becomes the cable transmitting USB signals (also known as USB over IP, USB/IP, USB over WiFi, ... Easiest might be to create a second bridge and bundle all WAN ports to it (that would be ether1, 4 and 5 in your case). Move DHCP client from ... When a device is configured in passthrough mode, it will be assigned a WAN IP instead of a LAN IP. Other devices connected to your gateway may ... I was able to connect it to a single PC which gets the public LTE ip. I can also plug ethernet 2 to one of the WAN ports of my dual router ... I have a range of IP addresses available from my ISP. Of which I used with a Mikrotic, it had PPPOE bridge, which allowed me to connect equipment on specific ... I am finally ready to seup mikrotik CCR router with home ISP gateway router trying to seup ip passthrough, but i am not sure where to find ... ... passthrough=yes add action=mark-connection chain=input in ... 2 WAN 1 LAN PPPoE Configuration In Mikrotik | 2 WAN Load Balancing. Is there an easy way to turn the Mikrotik router into an AP/Bridge(if that's the right terminology) so my Asus router will be issued the WAN IP address?