Unveiling the Secrets of MikroTik Passthru WAN Port for Seamless Networking

... WAN passthrough=no port=22,2200 protocol=tcp add action=mark-packet chain=postrouting new-packet-mark=prio1 passthrough=no port=8291 protocol= ... Unfortunately, as easy as most solutions are on MikroTik, these aren't simple. Many vendors like Ubiquiti have wizards that you can use during ... I was able to connect it to a single PC which gets the public LTE ip. I can also plug ethernet 2 to one of the WAN ports of my dual router ... As we need the address for port 9 which is the WAN port, we can add the last two hex number digits by 8 to get the correct MAC address (remember ... By default, connections from LAN to WAN are not restricted in any way. The only requirement us a working SRC-NAT configuration (which is there ... - The LAN network is connected to a managed switch, with the VLANs setup already. With the ASUS, this is working. ... How could I setup this in ... I'm using a Mikrotik router as LTE modem. The internet connection is configured as IP passthrough on the VLAN2. Vlan3 (192.168.88.1/24) is the management VLAN. I have a client connecting to our network with a Mikrotik CPE, I need to configure QoS on the CPE to give the RDP connections to port 3391 ... I will assume you have read MikroTik's documentation on PCC, Nth, Mangle etc. ... passthrough=no ###Incoming connections through ISP2 must ... Ideally the WAN would come in to the HAP AC at port 1, this ... add comment="WAN Passthrough VLAN" interface=ether5-trunk-to-b1 name ...